單片機
MPC7400 Part Number SpeciÞcationThis document describes part number speciÞc changes to recommended operating conditions and revised electrical speciÞcations,as applicable, from those described in the generalMP
This document describes part number speciÞc changes to recommended operating conditions and revised electrical speciÞcations,as applicable, from those described in the generalMPC7400 Hardware SpeciÞcations.
The MC68HC05K0 is a low cost, low pin countsingle chip microcomputer with 504 bytes of userROM and 32 bytes of RAM. The MC68HC05K0 isa member of the 68HC05K series of devices whichare available in 16-pin DIL or SOIC package
This application note shows how to write an Inter Integrated Circuit bus driver (I²C) for the Philips P90CL301micro-controller.It is not only an example of writing a driver, but it also includes a set of application interface
The P90CL301 is a highly integrated 16/32 bit micro-controller especially suitable for applications requiring lowvoltage and low power consumption. It is fully software compatible with the 68000. Furthermore, it provides bothstanda
This application note demonstrates how to write an Inter Integrated Circuit bus driver (I2C) for the XA-S3 16-bitMicrocontroller from Philips Semiconductors.Not only the driver software is given. This note also contains a set of (e
The XA-S3 is a member of Philips Semiconductors’ XA (eXtended Architecture) family of high performance 16-bit single-chip Microcontrollers. The XA-S3 combines many powerful peripherals on one chip. Therefore, it is suited for general mul
The 87LPC76X Microcontroller combines in a small package thebenefits of a high-performance microcontroller with on-boardhardware supporting the Inter-Integrated Circuit (I2C) bus interface.The 87LPC76X can be programmed both as
87LPC76X的IIC從程序
461Presents short and simple I2C software routines that support onlyslave (rather than master or master & slave) operation and an ASMdemonstration program. The slave-only software in this app notecomplements the master mode so
資料
- 資料
- IC元器件
相關推薦
換一換- 基于單片機的額溫槍設計
- MCU模塊原理圖資料
- 小華HC32L低功耗額溫槍開源方案
- 奮斗 STM32 開發板入門手冊
- 【開源】60余套STM32單片機、嵌入式Linux、物聯網、人工智能項目
- LAT1171+STM32F745 USART1 Bootloader 失敗原因分析與解決
- LAT1173高精度定時器的同步功能應用筆記
- LAT1178+關閉 SPI 會導致 WRPERR 錯誤的問題分析應用筆記
- LAT1180+STM32L4R9 的 QuadSPI Flash 通訊速率不理想應用筆記
- LAT1183+高精度定時器中 single-shot 計數模式不工作應用筆記
- LAT1185+一個地址未對齊引起的 HardFault 異常應用筆記
- LAT1187+在 Keil 中使用 STM32CubeProgrammer應用筆記
- LAT1189+Timer 結合 DMA 2D 通道實現不同波形輸出應用筆記
- LAT1198+通過 KEIL 制作 QSPI 接口的外部 Flash 下載算法應用筆記
- LAT1199+TrustZone 架構下使用 LPBAM 導致的 HardFault應用筆記
- LAT1202+TIM DMA burst 輸出變頻 PWM 波形應用筆記
- LAT1204+使用 NANOEDGE.AI 工具完成人體姿態識別應用
- AN5289 使用 STM32WB 系列微控制器構建射頻應用筆記
- LAT1214+使用 BlueNRG-LP SoC 方案無法掃描到擴展廣播包
- LAT1215+如何讓 STM32WB 在沒有 LSE 時運行 BLE 應用程序
- LAT1216 Blue NRG-1/2 系列芯片 Flash 操作與 BLE 事件的互斥處理
- LAT1218 如何選擇和設置外部晶體適配 BlueNRG-X
- LAT1220 關于 BlueNRG-2 在低功耗模式下的端口保持
- BlueNRG-X 如何實現外部天線和 PA 的控制















