In terms of low RON, the best pass transistor for a low-dropout, positive-voltage regulator is an N-channel MOSFET. All such commercially available regulators, however, use bipolar PNP pass transistors. The PNP transistor can saturate comp...

CNC系統的控制軟件及其工作過程 控制軟件是為完成特定CNC(或MNC)系統各項功能所編制的專用軟件，又稱為系統軟件(或系統程...

FANUC 7系統FANUC 7系統包括7 T和7 M兩個系列。其中7 T系統適用于兩坐標數控車床，7 M適用于三坐標銑床、鏜銑床和加工中心等。下面以7 M系統為例來說明其工作...

Shrinking electronic circuits place demands on power supplies to keep pace. The latest PCMCIA-card formats force designers to consider converter topologies and keep a watchful eye for components that meet ultrathin-design requirements....

With the advent of broadband access, many companies have developed high voltage SLICs (subscriber line interface card) which control the ringing and voice transmission on phone systems. The SLICs essentially perform two functions. One is r...

摘要：本應用筆記提供了一些利用Maxim API控制DS1WM 1-Wire總線主機的C語言例程。本文討論的內容基于DS1WM已經設計到FPGA或ASIC內，主控CPU通過API調用控制DS1WM。DS1WM通過兩個文件(DS1WM.c和...

Abstract: Unwanted electromagnetic radiation referred to as EMI is emitted by all electronic systems, including switching regulators. Adopting spread-spectrum pulse-width modulation (SSPWM) as a control scheme enhances the suppression of E...

More and more aspects of our lives depend on the uninterrupted operation of electronic equipment and appliances. "Drive by wire" and "fly by wire" have become everyday realities. In automated plants especially, electronic equipment that fa...

摘要：當熱插拔控制電路的輸出發生短路時，會觸發內部斷路器功能并斷開電路。但在內部斷路器做出反應之前，剛開始的短路電流可能達到數百安培。通常熱插拔控制器斷路器的...

Abstract: Output overvoltage protection is a critical feature for DC-DC converters in order to protect sensitive loads from permanent damage. The basic requirements for an overvoltage protection (OVP) circuit are precise sensing of the out...

Abstract: When it is necessary to plug in a board into a system that is currently powered, it is critical to control the inrush current to prevent damage/system fault conditions. This application provides a simple circuit to achieve this f...

摘要：歐盟最近頒布的限制有害物質指令(RoHS)禁止在電子電氣元件中使用金屬鉛(Pb)。受該指令影響，裝配流程也必須是無鉛的(無Pb)。盡管DS2502倒裝芯片在RoHS指令擁有豁免權，但其...

摘要：在筆記本電腦和便攜DVD應用中，音頻系統存在一個問題，即揚聲器的動態范圍有限，無法滿足實際應用的要求。由于受產品尺寸的制約，揚聲器的尺寸非常小，只能在有限的...

摘要：本文討論了汽車應用中的典型供電架構，并探討了如何在基本的電源設計中增加有源電壓限制功能，闡明了集成限壓器的必要性。文中還提供了幾個Maxim的有源電壓限幅器設計...

Abstract: This application note describes the hardware and software differences between the Dallas Semiconductor DS21Q42 and the DS21Q41B quad port framer devices. The DS21Q42 enhanced quad T1 framer offers a broader feature set while reta...

Abstract: Application Note 349 provides a detailed list of the features included in the DS2152L that are not included in the DS2151Q T1 single chip transceiver (SCT). All of the original features of the DS2151Q have been retained. All soft...

Abstract: Tech Brief 7 provides the requirements for multiplexing four PCM streams into one 8MHz system backplane using the Dallas Semiconductor/Maxim DS2152 and DS2154 T1/E1 single chip tranceivers (SCTs). The DS2155, DS26528, DS26524, DS...

Abstract: The application note describes how to design a backplane of 8.192MHz that simultaneously connects to any four framers of the following: DS21Q41 quad T1 framer, DS21Q43 E1 framer, DS2141 T1 controller, DS2151 T1 single chip transc...

Abstract: Application note 303 provides information on connecting the DS2151 and DS2153 single chip transceivers (SCTs) to a 16-bit DSP: the Analog Devices ADSP2181. Interconnections between the DS2151 or DS2153 parallel ...

Abstract: This application note describes how the DS2141A, DS2143, DS2151, and DS2153 interface to the SGS-Thomson M3488. Also shown are waveforms and timing diagrams of the different pins that are used for interfacing with M3488. ...